AGFA CR 30-X Service Manual page 435

DD+DIS150.06E
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0
Term
IP address
Jitter
Laser
LCD
LED
Leeds Phantom
LUT
mR
MCBF
MTTI
MTTR
MUSICA
Node
Pixel
RAM
RIS
ROI
ROM
RS232 interface
DOCUMENT CONTROL NOTE:
CR30-X
Type 5175/100
Glossary and Key Word Index
Short description
(Internet Protocol address) The address of a
computer attached to a TCP/IP network.
A flicker or fluctuation in a display image. To "jitter a
pixel" means to place it off side of its normal
placement by some random amount in order to
achieve a more natural antialiasing effect.
Light Amplification by Stimulated Emission of
Radiation
Liquid Crystal Display
Light Emitting Diode; Semi conductor emitting light.
Image Plate to check the technical image quality of
the CR. The Leeds Phantom was developed for
Agfa by the University of Leeds.
Look Up Table
milli Röntgen, measure for x-ray dose
1 mR corresponds to 8.7 μGy
Mean Cycles Between Failure
Mean Time To Install
Mean Time To Repair
Multiple Scale Image Contrast Amplification;
Agfa's image processing software
Nodes in the CAN bus system = printed circuit
board within the CAN bus.
Smallest addressable point to be scanned on the
film or plate. A maximum of 2048 per line may be
read by the Photomultiplier.
Random Access Memory
Volatile main memory of computers
Radiology Information System
Region Of Interest
Read Only Memory. A memory chip that
permanently stores instructions and data. Its
contents are created at the time of manufacture and
cannot be altered.
Serial interface which converts computer internal
parallel information into serial bits, and vice versa.
Chapter 12 / 3
Agfa Company Confidential