AGFA CR 30-X Service Manual page 227

DD+DIS150.06E
(5) Remove 3 upper screws.
(6) Open 3 lower screws at front cover a few
turns.
(7) Press two handles and pull out front cover
approx. 5 cm.
(8) Disconnect cable at user interface board.
See Figure 212.
(9) Disconnect ground cable at left hand side.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Figure 210
5175R3-5_004.cdr
Figure 211
Figure 212
Figure 213
Chapter 3.5 / 85
Agfa Company Confidential