Configuring Maintenance Indicator - AGFA CR 30-X Service Manual

DD+DIS150.06E
5.3

Configuring Maintenance Indicator

(1) In the CR 30-X Service Client select <Maintenance Indicator>.
(2) Configure whether maintenance indicator should be activated shown or not
(default = off).


(3) If required adapt the Change default target values for "Operating hours" and
"Cycles" according to the local terms of service agreement.
NOTE:
Changing the target values for operating hours and cycles is only available as of
software version CRE_1607.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 5
11-2009
Controls, Connections, and Setup Procedures
"On" (checkbox selected) means:
Customer will be reminded daily or when starting the Control PC to perform
about a preventive maintenance via following message:
"Maintenance interval will expire within a short time. Please contact
o
service." This message appears approximately 6 weeks before the
defined maintenance due date or due cycles (Default: 1 year / 12.000
cycles) are reached.
"Maintenance interval expired. Please contact service." appears, when
o
the maintenance due date or due cycles are expired is counter is
reached.
"Off" means: Maintenance indicator is deactivated. The customer will not be
reminded about preventive maintenance.
Operating Hours and Cycles only displayed if "Show Maintenance Indicator" is activated.
DOCUMENT CONTROL NOTE:
Type 5175 / 100/110
Figure 13
CR 30-X
8760
12000
5175_chapter1_22.cdr
Chapter 1 / 15
Agfa Company Confidential