AGFA CR 30-X Service Manual page 167

DD+DIS150.06E
(5) Remove 3 upper screws.
(6) Open 3 lower screws at front cover a few
turns.
(7) Press both handles and pull out front cover
approx. 5 cm.
(8) Disconnect cable at user interface board.
See Figure 54.
(9) Disconnect ground cable at left hand side.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Figure 52
5175R3-5_004.cdr
Figure 53
Figure 54
Figure 55
Chapter 3.5 / 25
Agfa Company Confidential