AGFA CR 30-X Service Manual page 241

DD+DIS150.06E
(13) Disconnect cables at Distributor board.
(14) Remove distributor board.
ASSEMBLY:
(1) Mount in reverse order.
(1) Switch on the digitizer.
Verification:
(2) Wait till the status indicator at the digitizer switches to green
(takes approx. 1,5 min.).
(3) Insert cassette with unexposed IP in the digitizer.
(4) At the workstation select examination type "System diagnosis – Flatfield".
(5) Select "ID" to identify the image: Scanning starts.
(6) Confirm that the image arrives at the workstation.
(7) Reject the image.
The Distributor Board is replaced.
Result:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Figure 240
Chapter 3.5 / 99
Agfa Company Confidential