Performing The Laser Beam Position Check; Performing The Laser Beam Position Adjustment - AGFA CR 30-X Service Manual

DD+DIS150.06E
The laser beam position check and adjustment is divided in following steps:
# Step
1

Performing the Laser Beam Position Check

2

Performing the Laser Beam Position Adjustment

3 Verifying the Laser Beam Position Check and
Adjustment
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 3
10-2009
5175_enc900.cdr
Figure 25: Distributor Board Version 2 is one prerequisite to perform the
"Laser Beam Position Check and Adjustment"
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Adjustments and Calibrations
Agfa Company Confidential
Distributor Board
Version 1
Distributor Board
Version 2
Section
2.5.1
2.5.2
2.5.3
Chapter 3.6 / 20