Leds And Switches On The Pmi / Pmi2 Board - AGFA CR 30-X Service Manual

DD+DIS150.06E
1

LEDS and Switches on the PMI / PMI2 Board

LED
FPGA_OK
+1,5 V
LD2 Watchdog
+ 5 V
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
04-2008
Electrical and mechanical Codes, Fuses, LEDs
5175_chapter3.4_001.cdr
*
LED not on PMI2
**
***
Figure 1
Meaning
Green LED, default ON. Program properly loaded.
Green LED, default ON. Voltage +1,5 V okay.
Red LED, default OFF. ON during reboot only (approx.
30 sec.) or if board operating system hangs
Green LED, default ON. Voltage +5 V okay.
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
FWI_green
FWI_orange
+24V_POL
**
+24V_POL
+12V_OPT
+12V_OPT
-12V_OPT
+12V_CAL
-12V_OPT
+20V_PMT
-10V_PMT
+8V_ANALOG -12V_OPT
+12V_CAN
+8V_DISP
+5V_PMT
+12V_CAL
-12V_OPT
+20V_PMT
-10V_PMT
+8V_ANALOG
+12V_CAN
+8V_DISP
+5V_PMT
**
LED only on PMI2
FWI_Orange only ON if FW cable connected
LED ON if digitizer idle
Agfa Company Confidential
*
Chapter 3.4 / 4