Solved Bugs With Software Cre_1509 Compared To Cre_1405; Misleading Error Messages In The Logfiles (Hq_0702280001); Missing Automatic E-Label Data Synchronization After Replacements (Hq_0704270003) - AGFA CR 30-X Service Manual

DD+DIS150.06E
NOTE:
All modules with E-labels have installation instructions enclosed, which describe the
correct proceeding.
8.2

Solved Bugs with Software CRE_1509 compared to CRE_1405

Software CRE_1509 contains following bug-fixes:
8.2.1

Misleading Error Messages in the Logfiles (HQ_0702280001)

Symptom
Digitizer logfiles contains misleading, obsolete error messages
Defect Software problem
Solution
Problem fixed in software CRE_1509
8.2.2 Missing automatic E-Label data Synchronization after Replacements
(HQ_0704270003)
Symptom 1
After replacement of an IP Handling Board (CM+9 5175 5230 X) it is possible that after
insertion of the cassette, during cassette clamping error 4152 pops up "Cassette fixer
detected unknown format".
Symptom 2
After replacement of a Slow Scan Board (CM+9 5175 2120 X) it is possible that the
aspect ratio of the scanned image is not exactly 1:1 anymore, but e.g. 1:0,99 or 1:1,01.
IMPORTANT:
Both symptoms only appear, if both of following conditions are fulfilled:

The digitizer at the production site which is used for board testing and the digitizer
on site, where the new boards are built in, deviate a lot in mechanical tolerances
concerning cassette clamping or the slow scan gear box.

The NX processing station is always switched on.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
01-2011
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175/100/105/110/120/125
Repair and Service
Software Releases and Patches
Agfa Company Confidential
Chapter 3.8 / 14