Boot-Up Time And Warm-Up Time; Interface Data; Service Data; Functional Data Image Plates - AGFA CR 30-X Service Manual

DD+DIS172.06E
9.7

Boot-up Time and Warm-up Time

Parameter
Boot-up time after switch on or reset [sec.]
Warm Up Time "Cold Start"
Warm Up Time "Warm Start" (Digitizer was > 30
min. in operation and not switched off for > 3 min.)
9.8

Interface Data

Parameter
Interface to NX workstation
9.9

Service Data

Parameter
Infocounter
Error diagnostics built in
Remote / preventive service capable
9.10

Functional Data Image Plates

Parameter
Image plate type
Image retention
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 5
11-2010
Within 1 hour:
After 2 hours:
After 24 hours:
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175/100/105/110/120/125
Installation Planning
Value
60

Image quality within
specification after boot-up
time.

Optimum image quality after
30 min.
Warm-up time = boot-up time
Value
IEEE 1394 (FireWire)
Value
yes
yes
yes
Value
MD40
Recommended readout time
70% of the stored energy is still
present with no visible loss of
information upon readout
Image retention still exceeds
45%. Slightly reduced image
quality
Chapter 11 / 24
Agfa Company Confidential
1 2 3