Service Client Menu "Maintenance Indicator - AGFA CR 30-X Service Manual

DD+DIS150.06E
2.2.17

Service Client Menu "Maintenance Indicator"

The menu "Maintenance Indicator" allows:
Purpose

To configure whether following messages shall pop-up at the processing station if
the maintenance indication target value ais reached:
o "Maintenance interval will expire within a short time. Please contact service."
This message appears approximately 6 weeks before the defined
maintenance due date or due cycles (Default: 1 year / 12.000 cycles) are
reached.
o "Maintenance interval expired. Please contact service." appears, when the
maintenance due date or due cycles are expired is counter is reached.

To reset the maintenance indicator counter.

To change the target values for operating hours and cycles.
(1) Select "Maintenance Indicator".
Usage
(2) Select "confirm" to reset the time/cycle counter.
(3) Switch off/on (default = on) the maintenance indicator.
Operating Hours and Cycles are only displayed if "Show Maintenance Indicator" is activated.
NOTE:
Changing the target values for operating hours and cycles is not available for software
version below CRE_1607.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2010
Figure 24
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Tools and auxiliary Means
8760
12000
Agfa Company Confidential
5175_chapter1_22.cdr
Chapter 3.2 / 31