AGFA CR 30-X Service Manual page 192

DD+DIS150.06E
(12) Remove cable at P23 of IP handling board.
(13) Open cable holders.
(14) Open 3 screws at the fixer stepper motor
(only 2 screws are shown in Figure 119).
(15) Remove the fixer stepper motor.
ASSEMBLY:
(1) Mount in reverse order. Observe IMPORTANT note below.
IMPORTANT:
Mount the motor with the motor cable outlet as
shown in the figure enclosed:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Figure 118
Figure 119
Figure 120
Chapter 3.5 / 50
Agfa Company Confidential