Scope Of This Document; Prerequisites For Installation - AGFA CR 30-X Service Manual

DD+DIS150.06E
1

Scope of this Document

This document describes the installation and configuration of the digitizer.
It is additionally required to perform installation and configuration of the
NX Workstation. Refer to Chapter 4 of the corresponding NX Workstation version in the
Mednet GSO Library: <GSO Library => Computed Radiography =>
CR Workstation Software>.
The required NX workstation documents are also available on CD-ROM as part of the
NX workstation delivery.
For installation instructions of optional digitizer components like "All-in-one Cart", UPS
or Wall Fixation Kit refer to the accompanying document of the option.
NOTE
The PC to which the digitizer is connected to is further named in this document:

Control PC, in its function to control the digitizer.

NX Workstation, in its function to have the NX image processing software
running on it.
NOTE:
The Installation Checklist in section 8 of this chapter gives an overview of all steps
of the digitizer installation and guides through the complete installation process.
2

Prerequisites for Installation

The purpose of this section is to show the required tasks before installation to
guarantee a smooth digitizer installation.
Task
Check installation site
prerequisites.
Prepare required tools.
*Complete required time per Task Code to be entered in the Agfa repair report.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 5
11-2009
Controls, Connections, and Setup Procedures
Required Importance
Time
15 minutes mandatory
5 minutes mandatory
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Task Code* Section
PRI
PRI
Chapter 1 / 4
Agfa Company Confidential
2.1
2.2