AGFA CR 30-X Service Manual page 215

DD+DIS150.06E
(31) Slide out axle.
(32) Replace belt.
ASSEMBLY:
(1) Mount in reverse order.
CALIBRATION:
(1) Perform a stall calibration for the roller clamping motor.
Refer to chapter 3.6, Adjustments.
(1) Insert cassette with unexposed IP in the digitizer.
Verification:
(2) At the workstation select examination type "System diagnosis – Flatfield".
(3) Select "ID" to identify the image: Scanning starts.
(4) Confirm that the image arrives at the workstation.
(5) Reject the image.
(6) Repeat steps (1) to (5) with each cassette format the customer is using.
The toothed belt Stepper Motor Roller Clamping is replaced.
Result:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Figure 181
Chapter 3.5 / 73
Agfa Company Confidential