Replacing The Drawer Motor (M4); Replacing The Fixer Stepper Motor (M1) - AGFA CR 30-X Service Manual

DD+DIS150.06E
(1) Switch on the digitizer.
Verification:
(2) Wait till the status indicator at the digitizer switches to green
(takes approx. 1,5 min.).
(3) Insert cassette with unexposed IP in the digitizer.
(4) At the workstation select examination type "System diagnosis – Flatfield".
(5) Select "ID" to identify the image: Scanning starts.
(6) Confirm that the image arrives at the workstation.
(7) Reject the image.
The permanent magnets are replaced.
Result:
2.15

Replacing the Drawer Motor (M4)

The replacement instructions for the Drawer Motor (M4), spare part number*
CM+9 5175 8690 0, are enclosed to the spare part.
* The last digit in the spare part number indicates the spare part revision at release of this document.
When ordering, the actual revision of the spare part is delivered.
2.16

Replacing the Fixer Stepper Motor (M1)

REQUIRED SPARE PART*:
CM+9 5175 5810 0
* The last digit in the spare part number indicates the spare
part revision at release of this document. When ordering,
the actual revision of the spare part is delivered.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Figure 111
Chapter 3.5 / 47
Agfa Company Confidential