After Software Upgrade Image Plate Transport Stops Before Scan Unit Due To Corrupted Slow Scan Board E-Label (Hq_0708220004) - AGFA CR 30-X Service Manual

DD+DIS150.06E
Defect
Missing automatic E-Label data synchronization between control PC (= NX processing
station) and digitizer for the IP handling board and slow scan board.
The E-label synchronization is falsely initiated by a reset of the control PC only .
Solution Automatic E-label synchronization with switch on of the digitizer implemented in
software CRE_1509.
NOTE:
A workaround for this symptom was already published with digitizer SB 15,
DD+DIS241.07E.
8.2.3 After software Upgrade Image Plate transport stops before Scan Unit due to
corrupted Slow Scan Board E-Label (HQ_0708220004)
Symptom
In some cases after software upgrade to CRE_1309 or exchange of the slow scan
board the digitizer stops scanning when the first image plate enters the scan unit, due
to a corrupted slow scan E-Label:
In this case the digitizer waits for information which is normally stored in the E-label.
No error message is issued. The digitizer boots-up properly, as the corrupted slow scan
board e-label parameters are not used during boot-up. With a reset the image plate is
returned in the cassette. Scanning the next image plate gives the same result.
Defect
Software problem: Slowscan eLabel entry "SpeedFactor" is not stored in parameter
database on control PC.
Solution In software CRE_1509 parameter "SpeedFactor" is correctly stored in parameter
database on control PC.
NOTE:
A preliminary solution for this symptom was already published with digitizer SB 20,
DD+DIS329.07E.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4
01-2011
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175/100/105/110/120/125
Repair and Service
Software Releases and Patches
Agfa Company Confidential
Chapter 3.8 / 15