Minimum Free Space For Operation And Maintenance - AGFA CR 30-X Service Manual

DD+DIS172.06E
5

Minimum free Space for Operation and Maintenance

Scale 1:20. Dimensions are in cm [inch].
NOTE:
If installed on the optional wheel table (see section 4.1) the digitizer can also be
installed in a corner.
Be aware, that the mains switch is in the rear. See section 8.1. At a corner installation
the mains switch may not be accessible.
IMPORTANT:
* The clearance in the rear for electrical connectors and to provide sufficient air flow
has to be at least 10 cm [3.9 in] in any case.
** At least 50 cm [19.7 in] space has to be provided on the right hand side to allow
cleaning of the scan line with the cleaning brush. This can be performed by the
customer.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 5
11-2010
> 10 [3.9]
60 [23.6]
80 [31.5]
60 [23.6]
Space required for operation
Space required for installation and repair
537511ac.cdr
DOCUMENT CONTROL NOTE:
Type 5175/100/105/110/120/125
> 50 [19.7]
*
60 [23.6]
Figure 7
CR 30-X
Installation Planning
60 [23.6]
80 [31.5]
Chapter 11 / 14
Agfa Company Confidential
1 2 3