AGFA CR 30-X Service Manual page 251

DD+DIS150.06E
LIST OF CONTENTS
1 OVERVIEW OF ADJUSTMENTS AND CALIBRATIONS.........................................................4
2 ADJUSTMENTS .......................................................................................................................5
2.1 Drawer Unit Adjustment ............................................................................................................5
2.1.1 Preparing the Drawer Unit Adjustment .....................................................................................6
2.1.2 Checking and Adjusting the lateral Position .............................................................................7
2.1.3 Checking and Adjusting the Height...........................................................................................9
2.2 PMI Board Carrier Position Adjustment ..................................................................................12
2.3 Cassette Unit Safety Switch Position Adjustment...................................................................14
2.3.1 Checking the Switch Position..................................................................................................15
2.3.2 Adjusting the Switch Position..................................................................................................15
2.4 Cassette Edge Sensor Position Adjustment ...........................................................................16
2.5 Laser Beam Position Check and Adjustment .........................................................................19
2.5.1 Performing the Laser Beam Position Check...........................................................................22
2.5.2 Performing the Laser Beam Position Adjustment ...................................................................25
2.5.3 Verifying the Laser Beam Position Check and Adjustment ....................................................28
3 CALIBRATIONS .....................................................................................................................29
3.1 Shading Calibration.................................................................................................................29
3.1.1 Verifying a successful Shading Calibration.............................................................................32
3.1.2 Possible Reasons for a failed Shading Calibration.................................................................33
3.1.3 Appendix: Changes in the Shading Calibration Procedure if Full Leg / Full Spine Cassettes
are in Use................................................................................................................................33
3.2 Stall Calibration .......................................................................................................................35
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 3
10-2009
Adjustments and Calibrations
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Chapter 3.6 / 3
Agfa Company Confidential