AGFA CR 30-X Service Manual page 137

DD+DIS150.06E
LED
/Reset
/M32_Reserve2
/M32_Reserve1
/FPGA_Test3
/FPGA_Test4
/CS3
/CS2
/CS1
/CS0
+5 V PMT
+8 V DISP
+12 V CAN
+8 V Analog
-10 V PMT
+20 V PMT
-12 V CAL
+12 V CAL
-12 V OPT
+12 V OPT
+24 V POL
+3,3 V
FWI_Orange
FWI_Green
*If these LEDs are off, this does not necessarily mean malfunction of the board. May depend on SW version,
how LED is programmed.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1
04-2008
Electrical and mechanical Codes, Fuses, LEDs
Meaning
Orange LED, default OFF. ON during board reset.
Green LED, default OFF. For R&D purpose only.*
Green LED, default ON. For R&D purpose only.*
Green LED, default ON. For R&D purpose only.*
Green LED, default OFF. For R&D purpose only.*
Green LED, default ON. For R&D purpose only.*
Green LED, default OFF. For R&D purpose only.*
Green LED, default OFF. For R&D purpose only.*
Green LED, default OFF. For R&D purpose only.*
Green LED, default ON. Voltage +5 V okay. Only
available on PMI2 board.
Green LED, default ON. Voltage +8 V for display okay.
Green LED, default ON. Voltage +12 V for CAN bus
okay.
Green LED, default ON. Voltage +8 V for analog circuit
okay.
Green LED, default ON. Voltage -10 V for PMT okay.
Green LED, default ON. Voltage +20 V for PMT okay.
Green LED, default ON. Voltage - 12 V for calibration
board okay.
Green LED, default ON. Voltage +12 V for calibration
board okay.
Green LED, default ON. Voltage -12 V for optic module
okay.
Green LED, default ON. Voltage +12 V for optic
module okay.
Green LED, default ON. Voltage +24 V for polygon
okay.
Green LED, default ON. Voltage +3,3 V okay.
Orange LED, default ON. FWI cable connected
between digitizer and processing station.
Green LED, default ON. Voltage for FireWire Interface
okay.
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Chapter 3.4 / 5
Agfa Company Confidential