Ci: Rfg Signal Source For Negative Limiting After Rfg; Ci: Rfg Input Signal For Limiting After Rfg / Rfg Lim Inp Sig; Ci: Setpoint Processing Signal Source For Rfg Setpoint; Ci: Rfg Signal Source For Valuation Factor 1 / Rfg Val_F 1 Sig S - Siemens SINAMICS DCM List Manual

p50633[0...3] CI: RFG signal source for negative limiting after RFG / RFG neg lim sig s
DC_CTRL Can be changed: T
Data type: Unsigned32 / FloatingPoint32
P-Group: -
Not for motor type: -
Min
-
Description: Sets the signal sources for negative limiting after the ramp-function generator (setpoint limiting).
Note: The maximum of the signals is forwarded to the limiter via connector input p50633[0 to 3].
p50634[0...1]

CI: RFG input signal for limiting after RFG / RFG lim inp sig

DC_CTRL Can be changed: T
Data type: Unsigned32 / FloatingPoint32
P-Group: -
Not for motor type: -
Min
-
Description: Sets the signal sources for the input signals in the case of limiting after the ramp-function generator (setpoint
limiting).
Note: The signals via connector input p50634[0 to 1] are added to the input and forwarded to "Limiting after ramp-function
generator".
p50635[0...n] CI: Setpoint processing signal source for RFG setpoint / RFG set sig s
DC_CTRL Can be changed: T
Data type: Unsigned32 / FloatingPoint32
P-Group: -
Not for motor type: -
Min
-
Description: Sets the signal source for the ramp-function generator's setpoint.
p50636[0...5]

CI: RFG signal source for valuation factor 1 / RFG val_f 1 sig s

DC_CTRL Can be changed: T
Data type: Unsigned32 / FloatingPoint32
P-Group: -
Not for motor type: -
Min
-
Description: Sets the signal sources for the valuation factors for ramp-function generator parameter set 1.
Index: [0] = Ramp-up time and ramp-down time
[1] = Initial rounding and final rounding
[2] = Ramp-up time
[3] = Ramp-down time
[4] = Initial rounding
[5] = Final rounding
Dependency: Refer to: p50303, p50304, p50305, p50306
SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
Calculated: -
Dyn. index: -
Unit group: -
Scaling: PERCENT
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: PERCENT
Max
-
Calculated: -
Dyn. index: CDS, p0170
Unit group: -
Scaling: PERCENT
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: PERCENT
Max
-
2 Parameters
2.2 List of parameters
Access level: 3
Func. diagram: 3155
Unit selection: -
Expert list: 1
Factory setting
[0] 52210[0]
[1] 52210[1]
[2] 52210[2]
[3] 52210[3]
Access level: 3
Func. diagram: 3155
Unit selection: -
Expert list: 1
Factory setting
[0] 52190[0]
[1] 0
Access level: 3
Func. diagram: 3135
Unit selection: -
Expert list: 1
Factory setting
52194[0]
Access level: 3
Func. diagram: 3150
Unit selection: -
Expert list: 1
Factory setting
1
491