Dynamic index
For parameters with a dynamic index [0...n], the following information is specified here:
• Data set (if available).
• Parameter for the number of indices (n = number - 1).
This field can contain the following information:
• "CDS, p0170" (Command Data Set, CDS count)
• "DDS, p0180" (Drive Data Set, DDS count)
• "EDS, p0140" (Encoder Data Set, EDS count)
Note:
Information on the data sets can be taken from the following references:
References:
Function diagram
The parameter is included in this function diagram. The structure of the parameter function and
its relationship with other parameters is shown in the specified function diagram.
P-Group (refers only to access via BOP (Basic Operator Panel))
Specifies the functional group to which this parameter belongs. The required parameter group
can be set via p0004.
Note:
Parameter p0004 is CU-specific (belongs to the Control Unit).
Unit, unit group and unit selection
The standard unit of a parameter is specified in square parentheses after the values for "Min",
"Max", and "Factory setting".
Note:
The units cannot be switched over for SINAMICS DCM.
The information under Unit Group and Unit Selection has no relevance.
SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
Example:
p1070[0] main setpoint [command data set 0]
p1070[1] main setpoint [command data set 1], etc.
SINAMICS DC MASTER operating instructions
"Data sets" Chapter
2 Parameters
2.1 Overview of parameters
21