2 Parameters
2.2 List of parameters
p51831[0...4]
Fuse monitoring activation / Fuse mon act
DC_CTRL
Can be changed: T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description:
Setting to activate/de-activate fuse monitoring on the Control Module.
Value:
0:
1:
Index:
[0] = Connector X23B
[1] = Connector X23C
[2] = Connector X23D
[3] = Connector X23E
[4] = Connector X23F
Dependency:
Refer to: F60004, F60204
Note:
The parameter is only effective on the Control Module.
Connector X23B is available on the power interface and on the expansion module (A7112 module). Monitoring at
connectors X23C to X23F is only possible using the expansion module.
Only groups of up to 6 inputs can be activated and de-activated at the same time.
If an expansion module is connected to slot X23A, slot X23B cannot be used on the power interface.
p51832
Fan monitoring configuration / Fan mon config
DC_CTRL
Can be changed: T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description:
Sets the configuration for fan monitoring on the Control Module.
Value:
0:
1:
2:
Dependency:
Refer to: r53140
Refer to: A60266, F60267
Note:
Fan monitoring is wired via input terminal 122/123.
The parameter can only be changed for the Control Module.
p51833
External fault mode / Ext F mode
DC_CTRL
Can be changed: T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description:
Sets the mode to trigger the external fault F60203 via input terminal 124/125 on the Control Module.
Value:
0:
1:
2:
Dependency:
Refer to: r53140
Refer to: F60203
554
Deactivated
Activated
OFF
ON and Low active
ON and High active
Switched off
Switched on and Low level triggers fault
Switched on and High level triggers fault
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
1
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
2
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
2
List Manual (LH8), 02/2015, 6RX1800-0ED76
Access level: 2
Func. diagram: 6957, 6965
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 2
Func. diagram: 8049
Unit selection: -
Expert list: 1
Factory setting
1
Access level: 2
Func. diagram: 6965, 8049
Unit selection: -
Expert list: 1
Factory setting
1
SINAMICS DCM