Full Parameter Name / Abbreviated Parameter Name; Drive Object (Function Module); Faults And Alarms - Siemens SINAMICS DCM List Manual

2 Parameters
2.1 Overview of parameters
Note:
The parameter list can contain parameters that are not visible in the expert lists of the particular
commissioning software (e.g. parameters for trace functions).
BICO: Full parameter name / abbreviated parameter name
The following abbreviations can appear in front of the parameter name:
• BI:
• BO:
• CI:
• CO:
• CO/BO: Connector/Binector Output
Note:
A connector input (CI) cannot be just interconnected with any connector output (CO, signal
source).
When interconnecting a connector input using the commissioning software, only the
corresponding possible signal sources are listed.

Drive object (function module)

A drive object (DO) is an independent, "self-contained" functional unit that has its own
parameters and, in some cases, faults and alarms.
When carrying out commissioning using the commissioning software, you can select/deselect
additional functions and their parameters by activating/deactivating function modules
accordingly.
The parameter list specifies the associated drive object and function module for each individual
parameter.
Example:
• r61000: PROFINET Name of Station
A parameter can belong to one, several, or all drive objects.
The following information relating to "Drive object" and "Function module" can be displayed
under the parameter number:
16
Binector Input
This parameter is used for selecting the source of a digital signal.
Binector Output
This parameter is available as a digital signal for interconnection with other
parameters.
Connector Input
This parameter is used for selecting the source of an "analog" signal.
Connector Output
This parameter is available as an "analog" signal for interconnection with other
parameters.
This parameter is available as an "analog" and digital signal for interconnection
with other parameters.
CU_DC (PROFINET)
The parameter is only available in the case of the CU_DC drive object with the "PROFINET"
function module.
List Manual (LH8), 02/2015, 6RX1800-0ED76
SINAMICS DCM