Installing Beater Bars - MacDon D65 Operator's Manual

4.14.2 Installing Beater Bars

To install beater bars, follow these steps.
1. Locate one beater bar (B) with one clamp set (C)
on auger tube and loosely secure with carriage
bolt (A) and nut. Bolt head MUST face direction of
auger rotation.
2. Locate remaining clamp sets on tube and loosely
attach to beater bar with carriage bolts and nuts. Bolt
heads MUST face direction of auger rotation.
3. Position second beater bar in clamps and secure with
carriage bolts and nuts.
4. Tighten bolts.
169899
OPERATION
Figure 4.69: Single Reel Headers
Figure 4.70: Beater Bars
87
Revision A