Stripper Bars; Adjusting The Stripper Bar - MacDon R85 Operator's Manual

Rotary disc 16-foot header for self-propelled windrower
Table of Contents

Advertisement

4.14 Stripper Bars

There are two adjustable stripper bars installed on the
pan at both ends of the auger that minimize wrapping of
material around the auger. The factory position should be
satisfactory for most crops, but bars can be adjusted for
specific conditions.
For fine stemmed crop, the auger performs best when the
stripper bars are positioned as close as possible to the
auger without rubbing.
Component wear and cutting in bumpy terrain where the
auger can contact the stripper bar may cause clearances
to become excessive resulting in feeding problems and
uneven windrows.
If material starts to accumulate between the auger flighting
and the strippers, the gap will need to be adjusted.
NOTE:
The stripper bars will likely require adjustment if the
auger position is changed.

4.14.1 Adjusting the Stripper Bar

If necessary, adjust the stripper bar as follows:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
1. Lower the header fully.
2. Stop the engine and remove the key.
3. Open the cutterbar door(s). Refer to
Doors, page
33.
4. Open the driveshield. Refer to
30.
214014
OPERATING THE HEADER
3.5 Cutterbar
3.4 Driveshields, page
113
Figure 4.44: RH Stripper Bar
Revision B

Advertisement

Table of Contents
loading

Table of Contents