Installing Beater Bars - MacDon D65 Operator's Manual

3.14.2 Installing Beater Bars

WARNING
To avoid bodily injury or death from unexpected
startup of machine, always stop engine and remove
key before making adjustments to machine.
1. Lower the header to the ground, stop the engine, and
remove the key from the ignition.
2. Position one beater bar (B) and one clamp set (C)
onto the auger tube and loosely secure with carriage
bolt (A) and nut. Bolt head MUST face the direction of
auger rotation.
3. Position the remaining clamp sets (C) onto the auger
tube and loosely attach to the beater bar (B) with
carriage bolts (A) and nuts. Bolt heads MUST face the
direction of auger rotation.
4. Position the second beater bar (B) in clamp sets (C)
and secure with carriage bolts (A) and nuts.
5. Tighten bolts.
147725
OPERATION
Figure 3.70: Single-Reel Headers
Figure 3.71: Beater Bars
87
Revision A