Replacing Draper Drive Roller Bearing - MacDon D65 Operator's Manual

11. Remove bolt (A) securing the opposite end of drive
roller (B) to the support arm.
12. Remove drive roller (B).

Replacing Draper Drive Roller Bearing

You will need a slide hammer to remove and replace the bearing on a drive roller.
1. Remove the draper drive roller assembly. For instructions, refer to
2. Remove bearing assembly (A) and seal (B) from roller
tube (C) as follows:
a. Attach slide hammer (D) to threaded shaft (E) in the
bearing assembly.
b. Tap out bearing assembly (A) and seal (B).
3. Clean the inside of roller tube (C), check the tube for signs
of wear or damage, and replace it if necessary.
214327
MAINTENANCE AND SERVICING
Figure 5.135: Drive Roller
Removing Draper Deck Drive Roller, page
Figure 5.136: Drive Roller Bearing
194
B
A
C
A D
E
A
192.
B
Revision B