Return Oil Filter; Removing Return Oil Filter - MacDon M2170 Operator's Manual

1. Park the windrower on level ground and position the drive
wheel so fill/drain plug (A) is at the lowest point.
2. Shut down the engine, and remove the key from
the ignition.
3. Place a container (about 5 liters [5.3 quarts]) under the fill/
drain plug (A).
4. Remove fill/drain plug (A) and check plug (B), and drain the
lubricant into container.
5. Dispose of oil in a manner that complies with the local rules
and regulations.
6. After the lubricant has drained completely, rotate the wheel
drive until fill/drain plug (A) is vertically centered with the
hub, and check port (B) on the wheel drive is horizontally
level with the center of the hub.
7. Add lubricant. For instructions, refer to
Wheel Drive Lubricant – 12 Bolt (Optional), page
8. Reinstall check plug (B) and torque it to 7.5 Nm (72 lbf·in).
9. Reinstall fill/drain plug (A) and torque it to 24 Nm (216 lbf·in).

5.6.9 Return Oil Filter

The return oil filter removes particulate contaminants from the oil returning from the fan drive, lift circuits, and drive
circuits. It must be changed after the first 50 hours and then at 500-hour intervals. Follow the service schedule on the
™
HarvestTouch Display.

Removing Return Oil Filter

The return oil filter removes particulate contaminants from the oil returning from the fan drive, lift circuits, and drive
circuits.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
DANGER
Avoid high-pressure fluids. Escaping fluid can penetrate the skin causing serious injury.
1. Shut down the engine, and remove the key from the ignition.
262170
MAINTENANCE AND SERVICING
Figure 5.47: Wheel Drive – 12 Bolt
5.10.6 Adding
425.
Figure 5.48: Wheel Drive – 12 Bolt
389
B
A
A
B
Revision A