Changing Oil And Oil Filter - MacDon M150 2008 Operator's Manual

g. Add oil as follows if level is below the LOW
mark: One U.S. qt. (1 litre) is will raise the level
from LOW to HIGH.
CAUTION
Do not fill above the HIGH mark.
1. Turn handle
counterclockwise
remove filler cap.
2. Carefully pour the oil.
Compliant With SAE Specs for API Class SJ
and CH-4 Engine Oil.
recommended to avoid spillage.
3. Replace oil filler cap (B) and turn handle (A)
clockwise until snug.
h. Close engine compartment hood.
Form 169017
MAINTENANCE/SERVICE – M150 ENGINE
A
B
(A) on filler cap
to loosen bung, and
Use SAE 15W40
A funnel is
7.9.4

Changing Oil and Oil Filter

The engine should be warm prior to
changing the oil.
a. Stop the engine and remove the key.
b. Place a drain pan of about 5 U.S. gallons (20
litres) under the engine oil drain.
c. Remove oil pan drain plug (C) and allow the oil
to completely finish draining.
(B)
d. Check the condition of the used oil. If either of
the following is evident, have your dealer correct
the problem before starting the engine:
1. Thin black oil indicates fuel dilution.
2. Milky discoloration indicates coolant dilution.
e. Open engine compartment hood to lowest
position.
f. Clean around the filter head (D).
g. Remove filter (E).
h. Clean gasket mating surface.
i. Apply a thin film of clean oil to the gasket on the
new filter.
j. Screw the new filter onto the filter mount until
the gasket contacts the filter head.
125
NOTE
C
D
E
(continued next page)
Issue – June 2008