Table of Contents
Advertisement
3. Remove the dipstick again. Check the oil level. The oil level
should be between the LOW (L) and HIGH (H) marks on the
dipstick. If the oil level is below the LOW mark, oil will need
to be added to the crankcase.
NOTE:
Adding 1.9 liters (2 U.S. quarts) of engine oil will raise the
level from LOW to HIGH.
4. Replace the dipstick. Turn the dipstick clockwise to lock it.
Adding engine oil
5. Clean the area around filler cap (A). Turn the cap
counterclockwise to unlock it. Remove the cap.
6. Use a funnel to add oil to the crankcase. For information on
the oil specifications, refer to the inside back cover.
IMPORTANT:
Do NOT overfill the crankcase with oil. Operating the
engine while it is overfilled with oil can damage the engine.
7. Install oil filler cap (A). Turn the cap clockwise until it
is snug.
4.1.4 Checking and Adding Hydraulic Oil
The hydraulic oil level will need to be inspected before the windrower is operated. It may be necessary to add hydraulic oil
to the reservoir.
WARNING
Do NOT inspect the hydraulic system for leaks using a part of your body. High-pressure fluid escaping through a pinhole
leak can penetrate the skin, causing serious injury.
262175
PERFORMING PREDELIVERY CHECKS
Figure 4.7: Engine Oil Level on Dipstick
Figure 4.8: Oil Filler Cap
52
A
Revision A
Advertisement
Table of Contents
