Converting From Transport To Field Position; Removing Tow-Bar - MacDon D65 Operator's Manual

4.15.3 Converting from Transport to Field Position

To convert the header from Transport to Field position, follow these steps.

Removing Tow-Bar

Remove tow-bar as follows:
1. Block the tires to prevent header rolling, and unhook
from towing vehicle.
2. Disconnect wiring connector (A) on tow-bar.
3. Remove pin (B) from tow-bar and disassemble outer
section (C) from inner section (D).
4. Disconnect wiring connector (A) at front wheel.
169899
OPERATION
Figure 4.71: Tow-Bar Assembly
A - Wiring Connector
C - Outer Section
Figure 4.72: Wiring Connector
90
B - Pin
D - Inner Section
Revision A