Setting Header Lower Rate - New Holland Cr And Cx Series; Setting Auto Header Height Control Sensitivity - New Holland Cr And Cx Series - MacDon NEW HOLLAND D2 Series Operator's Manual

1. Select HEADER RAISE RATE on the combine display.
2. Use the + or – buttons to change the setting.
3. Press ENTER to save the new setting.
NOTE:
The raise rate can be changed from 32–236 in increments
of 34. The factory setting is 100.
Setting Header Lower Rate – New Holland CR and CX Series
If necessary, the header lower rate (the automatic header height control button or second speed on the header height
rocker switch of the multifunction handle) can be adjusted.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator's manual for the most up-to-date information.
NOTE:
For New Holland CR models 6.80, 6.90, 7.90, 8.90, 9.90, and 10.90, refer to
and Later, page 198.
1. Select HEADER LOWER RATE on the combine display.
2. Use the + or – buttons to change the setting to 50.
3. Press ENTER to save the new setting.
NOTE:
The header lower rate can be changed from 2–247 in
increments of 7. It is factory-set to 100.
Setting Auto Header Height Control Sensitivity – New Holland CR and CX Series
The sensitivity adjustment controls the distance the cutterbar must travel up or down before the auto header height
control (AHHC) reacts and raises or lowers the feeder house.
When the sensitivity is set to maximum, only small changes in ground height are needed to cause the feeder house to raise
or lower. When the sensitivity is set to minimum, large changes in the ground height are needed to cause the feeder house
to raise or lower.
NOTE:
Changes may have been made to the combine controls or the display since this document was published. Refer to the
combine operator's manual for the most up-to-date information.
MAC215990
OPERATION
Figure 3.239: New Holland Combine Display
3.10.7 New Holland Combines – CR Series, 2015
Figure 3.240: New Holland Combine Display
196
Revision A