Calibrating M2 Series Windrower And Header On Harvesttouch ™ Display; Calibrating Knife Drive On Harvesttouch ™ Display - MacDon R113 Unloading And Assembly Instructions

11. Pull platform (A) toward the cab until it stops and the latch
is engaged.
12. Calibrate the header on the windrower. For instructions,
refer to 6.2.4 Calibrating M2 Series Windrower and Header
™
on HarvestTouch Display, page
6.2.4 Calibrating M2 Series Windrower and Header on HarvestTouch
™
The HarvestTouch Display recognizes when a header is attached to the windrower and determines which systems will
require calibration.
The following sensors may require calibration, depending on the type of header attached to the windrower:
• Header height
• Header angle
• Header float left
• Header float right
Refer to following topics for information on calibrating header systems:
•
Calibrating Knife Drive on HarvestTouch
•
Calibrating Header Position Sensors on HarvestTouch
Calibrating Knife Drive on HarvestTouch
When a header is attached to the windrower, the windrower's HarvestTouch
choose the appropriate settings for that header. Before it can be operated, however, the header's knife drive must be
calibrated to ensure that the knife drive pump output is accurate.
DANGER
Ensure that all bystanders have cleared the area.
NOTE:
This calibration MUST be performed with the engine running and the header engaged.
262300
ATTACHING HYDRAULIC AND ELECTRICAL COMPONENTS
76.
™
Display, page 76
™
Display, page 80
™
Display
Figure 6.31: Left Platform
• Reel height
• Reel fore-aft
• Swath compressor
• Knife drive
™
Display will recognize the header ID and
76
A
™
Display
Revision A