Adjusting Float Using Drawbolts - M Series Windrowers - MacDon R113 Unloading And Assembly Instructions

5. Set the left and right float fine adjustments on the CDM to approximately 5.0:
Using FLOAT SELECTOR switch (B), push + to increase the float or – to decrease the float on the left side of the
a.
header. CDM display (A) will show the selected float setting for the left side (for example: 5.0 L FLOAT R XX.X).
b. Repeat the previous step for the right side of the header float using switch (C). The display will show the float
setting for both sides, (for example, 5.0 L FLOAT R 5.0).
6. Shut down the engine, and remove the key from the ignition.
7. Grasp the end of the header and lift. The force to lift the end of the header should be 426–471 N (95–105 lbf) and
should be approximately the same at both ends.
10.4.1 Adjusting Float Using Drawbolts – M Series Windrowers
Coarse float adjustment is done using the drawbolts located on both sides of the windrower.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
DANGER
Ensure that all bystanders have cleared the area.
1. Start the engine.
2. Using HEADER UP switch (A) on the ground speed
lever (GSL), raise the header fully.
3. Shut down the engine, and remove the key from the
ignition.
4. Turn drawbolt (A) clockwise to increase the float, or
counterclockwise to decrease the float.
5. Recheck the header float. Refer to
Series Windrower, page 116
262300
PERFORMING PREDELIVERY CHECKS
10.4 Checking Float – M
for instructions.
A
Figure 10.12: GSL
Figure 10.13: Header Float Adjustment
117
A
Revision A