Lpuart Functional Description - ST STM32L4x6 Reference Manual

RM0351
37.4

LPUART functional description

Any LPUART bidirectional communication requires a minimum of two pins: Receive data In
(RX) and Transmit data Out (TX):
•
RX: Receive data Input.
This is the serial data input.
•
TX: Transmit data Output.
When the transmitter is disabled, the output pin returns to its I/O port configuration.
When the transmitter is enabled and nothing is to be transmitted, the TX pin is at high
level. In single-wire mode, this I/O is used to transmit and receive the data.
Through these pins, serial data is transmitted and received in normal LPUART mode as
frames comprising:
• An Idle Line prior to transmission or reception
•
A start bit
• A data word (7 or 8 or 9 bits) least significant bit first
•
1, 2 stop bits indicating that the frame is complete
• The LPUART interface uses a baud rate generator
•
A status register (LPUART_ISR)
•
Receive and transmit data registers (LPUART_RDR, LPUART_TDR)
•
A baud rate register (LPUART_BRR)
Refer to
The following pins are required in RS232 Hardware flow control mode:
•
CTS: Clear To Send blocks the data transmission at the end of the current transfer
when high
•
RTS: Request to send indicates that the LPUART is ready to receive data (when low).
The following pin is required in RS485 Hardware control mode:
•
DE: Driver Enable activates the transmission mode of the external transceiver.
Note: DE and RTS share the same pin.
Low-power universal asynchronous receiver transmitter (LPUART)
Section 37.7: LPUART registers for the definitions of each bit.
DocID024597 Rev 3 1247/1693
1282