Setting Static Cmc And Bmc Internal Ip Addresses - Cisco UCS S3260 Service Manual

Initial System Setup
Remove the KVM cable from the server node.
Step 15
Each CMC in the SIOCs and each BMC in the server nodes must have an internal IP address assigned
Note
in order for the system to operate (see
server assigns these addresses and no further steps are required.
This step only for setting static IPs (DHCP disabled)—Set the CMC and BMC internal IP addresses
Step 16
by using the Cisco IMC interface, as described in
page

Setting Static CMC and BMC Internal IP Addresses

If you left DHCP enabled, your DHCP server sets the CMC and BMC IP addresses and so these steps
Note
are not required. Perform the following procedure only if you are setting static IP addresses manually.
Use a browser and the system management IP address to connect to the Cisco IMC management
Step 1
interface.
Log in at the login page. The default user name for the system is admin. The default password is
Step 2
password.
The Chassis/Summary page opens. The Management IP Address is displayed. The IP address for each
CMC is displayed at this point only if a DHCP server assigned them.
Click the menu button at the upper-left corner
Step 3
The Networking/Network Settings page opens.
Scroll down to the Individual Settings area.
Step 4
Fill in your static IP addresses for CMC1, CMC2, BMC1, and BMC2.
Step 5
All available component IP addresses must be set together to complete the configuration. Partial settings
Note
result in an error and the partial settings are not saved.
The IP addresses for the management IP, the SIOC CMC IPs, and the server BMC IPs must all be
Note
configured on the same subnet.
This task can be completed using the management GUI or CLI interfaces. For more information see
Cisco UCS C-Series Integrated Management Controller GUI Configuration Guide for S3260 Servers or
the Cisco UCS C-Series Integrated Management Controller CLI Configuration Guide for S3260 Servers
here:
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
2-18
2-18.
Configuration Guides.
System IP Addresses, page
Setting Static CMC and BMC Internal IP Addresses,
and select Admin > Networking.
Chapter 2 Installing the System
2-14). If DHCP is enabled, your DHCP