Installation; Power Tilt Relay/Power Tilt Relay Case Removal/Installation - TOHATSU BFT250A Service Manual

dummyhead dummyhead
OTHER ELECTRICAL
POWER TILT RELAY/POWER TILT
RELAY CASE REMOVAL/

INSTALLATION

Disconnect the battery negative (–) cable, then the
positive (+) cable from the battery.
Remove the engine cover.
Remove the bolt (6 x 12 mm) [1], power tilt relay ground
terminal [2] and two wire harness clips [3].
Disconnect the following:
– Power tilt motor 2P connector [1]
– Power tilt relay 1P connector [2]
– HO2S 4P connector [3]
– Power tilt relay 2P connector [4]
Remove the three bolt/washers (6 x 27 mm) [1], wire
harness clip [2], and two harness band clips [3].
10-6
[1]
[2]
[3] [1]
[2] [3]
[3]
[2]
[4] [4]
[3]
[1]