Crypto Map Manual Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
C M M
RYPTO AP
To activate the Crypto Map Manual mode, enter a valid version of the crypto map ipsec-manual
command at the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#crypto map Map-Name 10 ipsec-manual
ProCurve(config-crypto-map)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
All other commands for this command set are described in this section in alphabetical order.
antireplay on page 1240
ike-policy <policy number>
match address <listname>
set peer <address>
set session-key [inbound | outbound]
set transform-set <setname>
5991-2114
C
ANUAL OMMAND
on page 1434
on page 1241
on page 1242
on page 1244
on page 1245
on page 1249
© Copyright 2007 Hewlett-Packard Development Company, L.P.

Crypto Map Manual Command Set

S
ET
on page 1431
1239