Properties; Table 7-3 Tsa > Project > Properties Menu Description - Keysight U8903B User Manual

7 Test Sequence Application

Properties

The TSA > Project > Properties menu page is displayed as shown in Figure 7-4.
Figure 7-4
Table 7-3 TSA > Project > Properties menu description
Menu Description
Press the Prompt DUT ID softkey to enable or disable the prompt for device ID (device serial number) at the start of a test
Prompt DUT ID
sequence.
Prompt Msg Press the Prompt Msg softkey to set the prompt message. This setting is only available when Prompt DUT ID is enabled.
Press the Pass/Fail Msg softkey to enable or disable the on-screen message dialog box that can be displayed at the end of
Pass/Fail Msg
a test sequence. Press Enter to close the dialog box.
Press the Pass Message softkey to edit the pass message. If all the measurements in the test sequence pass, the pass
Pass Message
message is displayed. The default message is "Passed". This setting is only available when Pass/Fail Msg is enabled.
Press the Fail Message softkey to edit the fail message. If one or more measurements in the test sequence fails, the fail
Fail Message
message is displayed. The default message is "Failed" This setting is only available when Pass/Fail Msg is enabled.
296
TSA > Project > Properties menu page
Keysight U8903B User's Guide