Optional: Using Rtsa To Verify The Signal Quality; And Preamp Option 235) - Keysight A Series User Manual

Over–the–Air Measurements (OTA) – LTE FDD Option 370, LTE TDD Option 371, 5GTF
Option 377 (CPU2 Only)
How to Set Up Over–the–Air (OTA) Mode Settings
Optional: Using RTSA to verify the signal quality (Requires Option 350

and Preamp Option 235)

— Press Mode >
— Press Freq/Dist >
— Press Scale/Amptd
Figure 13-12 Using RTSA to verify LTE FDD 751 MHz signal quality–20 dB Signal to Noise
Displayed (Requires Option 350 and Preamp Option 235)
372
RTSA
— Then Density Spectrum
Center
(For this example, Center = 751 MHz.)
— Then Preamp [ON]
— Then Ref Level (Default). Then use the
or numeric keypad to position the trace for optimum viewing on the
FieldFox display. Refer to
You should see a ~20 dB or greater LTE FDD signal–to–noise level. If not
refer to "Troubleshooting" on page
(Default)
(Default) > 751 MHz
Figure 13-12 on page
401.
Keysight N9927-90020 User's Guide
arrows, the rotary knob,
372.