Set Level - Dell Z9500 Command Reference Manual

Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
ip community-list
Commands
match community
]neighbor send-community
show ip bgp community
show ip community-lists

set level

To specify the IS-IS level or OSPF area to which matched routes are redistributed, configure a filter.
Z9500
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-
area}
To remove a set level condition, use the no set level {backbone | level-1
| level-1-2 | level-2 | stub-area} command.
Parameters
backbone
level-1
Access Control Lists (ACL)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures community access list.
— redistributes routes that match the COMMUNITY attribute.
— assigns the COMMUNITY attribute.
— displays BGP community groups.
— displays configured Community access lists.
Enter the keyword backbone to redistribute matched routes
to the OSPF backbone area (area 0.0.0.0).
Enter the keyword level-1 to redistribute matched routes
to IS-IS Level 1.
323