Match Tag - Dell Z9500 Command Reference Manual

Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
match interface
Commands
match ip address
match ip next-hop
match ip route-source
routers.
match metric

match tag

match tag
To redistribute only routes that match a specified tag value, configure a filter.
Z9500
Syntax
match tag tag-value
To remove a match, use the no match tag command.
Parameters
tag-value
316
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match an IP address.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a specific metric.
— redistributes routes that match a specific tag.
Enter a value as the tag on which to match. The range is
from zero (0) to 4294967295.
Access Control Lists (ACL)