Avaya Communication Manager Administrator's Manual page 498

Administering Media Servers
SNMP Agents
Figure 60: SNMP Agents
2
Check the
the Start/Stop button displays Start. In this case, CMSAs cannot operate. To restart the SNMP
master agent, click Start.
If the SNMP master agent is running, the Start/Stop button displays Stop. To stop the SNMP
master agent, click Stop.
3
In the Communication Manager SNMP Agent section, check the Enable Agent box.
If this box is checked, an SNMP manager can interact with Communication Manager using this
CMSA and MIB-II sub-agent within the restrictions administered on this screen.
If this box is not checked, SNMP access to Communication Manager is denied. Disabling this
CMSA does not inhibit access to the SNMP master agent or MIB-II sub-agent running on this
server.
If you check the Enable busy-out / release and QOS parameter setting box, this CMSA can be
used to busyout and release boards, ports, trunk groups, and trunk members. The CMSA can also
be used to set QOS parameter settings (using SNMP commands).
4
In the Password field under
this CMSA uses to log in to the call-processing software.
5
In the Re-enter Password field, repeat the new password.
NOTE:
If these password fields are not administered correctly, all SNMP requests to the CMSA
will fail..
6
In the SNMP Version 1 section, check the Enable SNMP Version 1 box if SNMP Version 1 is
needed.
This is the SNMP version of the protocol to be used in communicating with the CMSAs on the
server.
NOTE:
The Community Name fields are the authentication mechanism for SNMP v1 and v2c.
The name can contain up to 50 characters. Any character can be used except ". There must
be no spaces and the text is case sensitive.
498
field for status of the SNMP Master Agent. If the agent is down,
Master Agent status
Agent ACP Login
Administrator's Guide for Avaya Communication Manager
, enter a new password to change the password
November 2003