Door Frame Installation Four Door Models - If Equipped - Jeep WRANGLER 2020 Owner's Manual

3. Lift the frame upward, removing it from the
vehicle.
Step Three
4. Store screws in a secure location.
5. Repeat procedure on the front door frame
(four door models).
WARNING!
Do not drive your vehicle on public roads

with the door frame(s) removed as you will
lose the protection that they can provide.
This procedure is furnished for use during
off-road operation only.
WARNING! (Continued)
Do not drive your vehicle on public roads

with the doors removed as you will lose the
protection that they can provide. This
procedure is furnished for use during
off-road operation only.
Door Frame Installation Four Door Models —
If Equipped
1. Install the front door rail first.
2. Carefully place the front door rail in the
rubber seal at the top of the windshield, and
line up the holes for the Torx head screws
(two for each door).
3. Swing the frame bracket around the side of
the rail, and insert the screws from
underneath. Tighten with #40 Torx head
driver until they are snug, being careful not
to cross-thread the screws or overtighten.
Refer to the table below for the appropriate
torque specifications for the door rail
screws.
(Continued)
GETTING TO KNOW YOUR VEHICLE
Step Three
Torque
Specification
Maximum
For Torx
Screws
8.8 in-lbs 11.0 in-lbs
12 N· m 15 N·m
CAUTION!
Do not overtighten the screws. You can strip
the screws if they are overtightened.
73
2
Minimum
6.6 in-lbs
9 N·m