IPv6 Commands
ipv6 rip garbage-timer
Configures the RIPng garbage timer value. When a route in the RIB exceeds the configured Invalid Timer
Value, the route is moved to a "Garbage" state in the the RIB. The garbage timer is the length of time a
route will stay in this state before it is flushed from the RIB.
ipv6 rip garbage-timer seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Use the
ipv6 rip invalid-timer
Examples
-> ipv6 rip garbage-timer 180
Release History
Release 7.1.1; command was introduced.
Related Commands
ipv6 rip invalid-timer
ipv6 rip holddown-timer
MIB Objects
alaProtocolripng
alaRipngGarbageTimer
OmniSwitch CLI Reference Guide
Time, in seconds, that a route will remain in the RIPng Routing Table
before it is flushed from the RIB. Valid range is 0 - 180.
default
120
command to set the Invalid Timer Value.
Configures the amount of time a route remains active in RIB before
being moved to the "Garbage" state.
Configures the amount of time a route is placed in a holddown state.
March 2011
ipv6 rip garbage-timer
page 11-73