Ip Udp Relay Port - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip udp relay port

ip udp relay port
Enables or disables UDP port relay for user-defined service ports that are not well-known.
ip udp relay port port_num [description description]
ip udp relay no port port_num
Syntax Definitions
port_num
description
Defaults
By default, relay is enabled on the BOOTP/DHCP well-known ports.
parameter
name
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to disable the user-defined service for the specified port.
•
Use the port parameter to specify service port numbers that are not well known.
Examples
-> ip udp relay port 54
-> ip udp relay port 54 description "Generic Service"
-> ip udp relay no port 54
Release History
Release 7.1.1; command introduced.
Related Commands
ip udp relay service vlan
page 15-20
A service port number that is not well-known or user-defined.
A description of the user-defined service for the specified port.
default
UDP port #
Specifies the VLAN to which traffic from the specified UDP service
port is forwarded.
DHCP Relay Commands
OmniSwitch CLI Reference Guide March 2011