Vrrp Set - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

vrrp set

vrrp set
Sets the new default parameter values to existing virtual routers on the switch.
vrrp set [interval | priority | preempt | all | none] [ override]
Syntax Definitions
interval
priority
preempt
all
none
override
Defaults
parameter
interval | priority | preempt | all all
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
All the virtual routers must be disabled before using this command.
•
To apply the new default value to the existing virtual routers, you must first disable the virtual routers,
then apply the new default value using the vrrp set command and enable the virtual routers again.
•
If any of the virtual routers are running with their own configured value or group value, then that value
will take priority over the new default value. To override the configured value with the new default
value, you must first disable the virtual routers, then override the configured value using the vrrp set
command with the override option and enable the virtual routers again.
Examples
-> vrrp set priority
-> vrrp set priority override
Release History
Release 7.1.1; command was introduced.
page 16-20
Sets the VRRP advertisement interval value to the new default value.
Sets the priority value to the new default value.
Sets the preempt mode to the new default mode.
Sets all the parameters value to the new default value.
Resets all the parameter values to their default values.
Overrides the specified parameters configured value with the new
default value.
default
OmniSwitch CLI Reference Guide
VRRP Commands
March 2011