Ip Bgp Neighbor Bfd-State - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip bgp neighbor bfd-state

ip bgp neighbor bfd-state
Enables or disables BFD for a specific BGP neighbor.
ip bgp neighbor ipv4_address bfd-state {enable | disable}
Syntax Definitions
ipv4_address
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 10K
Usage Guidelines
The BFD status for BGP must be enabled before BGP can interact with BFD.
Examples
-> ip bgp neighbor 135.10.10.2 bfd-state enable
-> ip bgp neighbor 135.10.10.2 bfd-state disable
Release History
Release 7.1.1; command was introduced.
Related Commands
ip bgp bfd-state
ip bgp bfd-state all-neighbors
MIB Objects
alaBgpPeerEntry
alaBgpPeerName
alaBgpPeerBfdStatus
alaBgpGlobal
alaBgpBfdAllNeighbors
page 14-22
The IP address of the BGP neighbor.
Enables BGP neighbor.
Disables BGP neighbor.
default
disable
Enables or disables BGP with BFD protocol.
Enables or disables BFD for all BGP neighbors.
OmniSwitch CLI Reference Guide
BFD Commands
March 2011