Ip Rip Interface Send-Version - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

RIP Commands

ip rip interface send-version

Configures the send option for a RIP interface. This defines the type(s) of RIP packets that the interface
will send.
ip rip interface {interface_name} send-version {none | v1 | v1compatible | v2}
Syntax Definitions
interface_name
none
v1
v1compatible
v2
Defaults
parameter
none | v1 | v2 | v1compatible
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Using this command will override RIP default behavior.
•
Other devices must be able to interpret the information provided by this command or there will not be
proper routing information exchanged between the switch and other devices on the network.
Examples
-> ip rip interface rip-1 send-version v1
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
The name of the interface.
RIP packets will not be sent by the interface.
Only RIPv1 packets will be sent by the interface.
Only RIPv2 broadcast packets (not multicast) will be sent by the inter-
face.
Only RIPv2 packets will be sent by the interface.
default
v2
March 2011
ip rip interface send-version
page 13-9