Show Ipv6 Redist - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

show ipv6 redist

show ipv6 redist
Displays the IPv6 route map redistribution configuration.
show ipv6 redist [rip | ospf | bgp]
Syntax Definitions
rip
ospf
bgp
Defaults
By default all route map redistribution configurations are shown.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Specify a destination protocol with this command to display only those configurations that redistribute
routes into the specified protocol.
•
The IPv6 version of BGP is not supported in the current release.
Release History
Release 7.1.1; command was introduced.
Examples
-> show ipv6 redist
Source Destination
Protocol Protocol
------------+------------+---------+--------------------
localIPv6 RIPng
RIPng OSPFv3
-> show ipv6 redist ospf
Source Destination
Protocol Protocol
------------+------------+---------+--------------------
RIPng OSPFv3
page 11-66
Displays the route map redistribution configurations that specify RIP as
the destination (into) protocol.
Displays the route map redistribution configurations that specify OSPF
as the destination (into) protocol.
This parameter is not supported.
Status Route Map
Enabled ipv6rm
Enabled ipv6rm
Status Route Map
Enabled ipv6rm
OmniSwitch CLI Reference Guide
IPv6 Commands
March 2011