Ip Helper Boot-Up Enable - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

DHCP Relay Commands

ip helper boot-up enable

Specifies the type of packet to broadcast (BootP or DHCP) when automatic IP address configuration is
enabled for the switch.
Note. Automatic IP address configuration only supports the assignment of a permanent IP address to the
switch. Make sure that the DHCP server is configured with such an address before using this feature.
ip helper boot-up enable {BOOTP | DHCP}
Syntax Definitions
BOOTP
DHCP
Defaults
parameter
BOOTP | DHCP
Platforms Supported
OmniSwitch 10K
Usage Guidelines
This command is only valid if automatic IP address configuration is already enabled for the switch.
Examples
-> ip helper boot-up enable DHCP
-> ip helper boot-up enable BOOTP
Release History
Release 7.1.1; command introduced.
Related Commands
ip helper boot-up
MIB Objects
iphelperStatTable
iphelperBootupPacketOption
OmniSwitch CLI Reference Guide
Broadcasts a BOOTP formatted request packet.
Broadcasts a DHCP formatted request packet.
default
BOOTP
Enables or disables automatic IP configuration for the switch.
March 2011
ip helper boot-up enable
page 15-19